Changing The Hydraulic Filter - Toro Field Pro 604 Operator's Manual

Changing the Hydraulic
Filter
Service Interval: Every 300 hours
Removing the Hydraulic Filter
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Lower the operator's cushion; refer to
the Operator's Cushion (page
3. Align the drain pan under the hydraulic filter.
4. Remove the filter from the filter head
Figure 94
1. Filter head
44).
Lowering
46).
(Figure 94).
g366695
2. Filter
Installing the Filter
1. Clean the filter mounting flange of the filter head.
2. Apply a thin coat of the specified hydraulic
fluid to the gasket of the new filter; refer to
Hydraulic-Fluid Specifications (page
3. Fill the filter with the specified hydraulic fluid.
4. Thread the filter onto the filter head until the seal
contacts the mounting flange, then tighten the
filter an additional 1/2 turn.
5. Star the engine, check for leaks around the filter
and filter head, shut off the engine, and remove
the key.
Note:
Repair all hydraulic leaks.
6. Raise and secure the operator's cushion; refer
to Raising the Operator's Cushion (page
59
58).
46).