Table of Contents
Advertisement
Product Overview
Specifications
Traction-unit compatibility
Height of cut
Height-of-cut range
Reel bearings
Rollers
Grass shield
Counterweight
Net weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
www.Toro.com
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
The dethatching unit mounts on the Greensmaster 3000, 3000-D, 3050, 3100, 3150, 3250-D
and 3150-Q traction units.
Dethatching depth is adjusted on the front roller by 2 vertical screws and held by 2 locking
capscrews
Bench HOC range is 4.78 mm (0.188 inch) below ground level to 6.35 mm (0.250 inch)
above ground level.
Two sealed stainless steel deep groove ball bearings, 30 mm inside diameter slip fit onto reel
shaft retained by internally splined threaded drive insert. Additional inboard seal / slinger
along with sealed external bearing housing for added protection. Reel position is maintained
by a wave washer with no adjusting nut.
The rear roller is a 5.1 cm (2 inch) diameter steel full roller.
Non-adjustable shield with adjustable cutoff bar to improve grass discharge from reel in
wet conditions
A cast iron weight mounted opposite to the drive motor balances the dethatching unit.
31 kg (68 lb)
for a list of all
8
Operation
Training Period
Before operating the dethatching unit on a green,
evaluate the performance of the dethatching unit at
the desired setting. Operate in a clear, unused area
to determine if the desired results will be achieved.
Adjust the dethatching unit when changing settings
as desired.
Note:
When the dethatching units are mounted on
Greensmaster 3200, 3200-D or 3250-D traction units
and are operated under heavy loads, you may need
to adjust the carrier frame and unit circuit relief valve.
Operating Tips
•
Operate the traction unit at full throttle, varying the
ground speed to meet dethatching loads.
•
The maximum recommended negative setting on
the dethatching blades is 5 mm (3/16 inch) deep
penetration.
•
The power requirements to operate the dethatching
unit will vary with turf and soil conditions.
•
The travel speed may need to be reduced in some
conditions.
Advertisement
Table of Contents
