Operation; Operating The Power Take Off (Pto); Operating The Attachment Lift Lever - Toro 79362 Operator's Manual

Operation

Danger
When snowthrower is attached to the tractor,
without additional weight, the tractor may
become unstable.
NEVER operate tractor, equipped with
snowthrower, unless 100 lb. rear wheel weights
are installed.
Danger
Contact with rotating auger and thrown debris
can cause severe injury or death.
Stay away from the discharge and auger
openings while operating the snowthrower.
Keep your hands, feet, and any other part of
your body or clothing away from concealed,
moving or rotating parts.
Use a stick, not your hand, to remove
obstructions from discharge chute or auger
housing.
Before adjusting, cleaning, repairing and
inspecting the snowthrower and before
unclogging the discharge chute, shut off the
engine and wait for all moving parts to stop.
Move the power take off (PTO) to off and
rotate the ignition key to off. Remove the key.
Operating the
Power Take Off (PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
The PTO light, in the Indicator Module, will be on when
the ignition key is in run or lights position and the power
take off (PTO) is engaged. When this light is on it is a
reminder the starter will not crank and to turn the off PTO
before getting off the tractor.
Engaging the Power Take Off (PTO)
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull the power take off (PTO) to on (Fig. 13).
1
Figure 13
1. PTO—Off
Disengaging the Power Take Off (PTO)
1. Depress the clutch and brake pedals to stop the
machine.
2. Push the power take off (PTO) to off (Fig. 13).
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 14) is used to raise and
lower various attachments.
Raising the Snowthrower
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward until latch locks. In
this position the lift will hold the snowthrower in the
up, or raised position.
Lowering the Snowthrower
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the
latch. Move lift lever forward to lower the
snowthrower.
11
2
m–4201
2. PTO—On