Table of Contents
Advertisement
7.
On the left end of the dethatching unit, apply
a light coating of oil to the O-ring and install
the counterweight with the screws previously
removed.
Note:
Torque the screws to 16 to 20 N-m (12
to 15 ft-lb).
3
Installing the Hoop Link,
Offset Link, or Chain Link
No Parts Required
Procedure
For dethatching units that will be mounted on a
traction unit with a serial number prior to 240000001,
the proper lift link must be obtained and installed.
The 2 capscrews used to mount the hoop, offset,
or chain link are installed on the dethatching unit.
Remove these screws and use them to install your
required link.
•
A hoop link (Part No. 105-5740) as shown in
Figure 5
is required for the Greensmaster 3000,
3000-D, 3050, 3100, 3150, and 3150-Q traction
units (it is supplied with the above Greensmaster
traction units).
1.
Install the hoop link to the top of the
dethatching unit with 2 capscrews.
2.
Torque the capscrews to 34 to 40 N∙m (25
to 30 ft-lb).
1. Hoop link
Figure 5
•
An offset link (Part No. 110-2397) is required
for the Greensmaster 3250-D traction units (it is
supplied with the Greensmaster 3250-D traction
unit).
1.
Position the lift hook offset toward the front
of the dethatching unit.
2.
Install the offset link
the dethatching unit with 2 capscrews.
3.
Torque the capscrews to 34 to 40 N∙m (25
to 30 ft-lb).
1. Offset lift hook
•
A chain link (Part No. 106-2601) and a mounting
bracket (Part No. 105-5738) may also be used on
the Greensmaster 3250-D traction unit.
1.
Install the chain link to the top of the
dethatching unit with the mounting bracket
and 2 capscrews.
2.
Torque the capscrews to 34 to 40 N∙m (25
to 30 ft-lb)
Note:
When mounting the dethatching unit to the
traction unit, hook the wider end of the chain link
to the lift arm.
g011931
5
(Figure
6) to the top of
Figure 6
(Figure
7).
g008414
Advertisement
Table of Contents
