Checking The Transaxle-Fluid Level; Changing The Transaxle Fluid - Toro Workman UTX Operator's Manual

Checking the
Transaxle-Fluid Level
Service Interval: Every 250 hours
Fluid Type: Toro Premium Synthetic Transaxle Fluid
(Toro Part 145-2048)
1. Park the machine on a level surface.
2. Shift the transmission lever to the P (P
position.
3. Shut off the engine and remove the key.
4. Remove the fill plug on the transaxle
106).
Note:
The fluid level should be even with the
bottom of the fill plug.
5. If the fluid level is low, remove the fill plug and
add the specified fluid until it runs out of the hole
(Figure 106).
6. Replace the fill plug and torque it to 14 to 30
N∙m (10 to 22 ft-lb).
Figure 106
1. Drain plug
)
ARK
(Figure
g362542
2. Fill plug
Changing the Transaxle
Fluid
Service Interval: Every 500 hours
Fluid Type: Toro Premium Synthetic Transaxle Fluid
(Toro Part 145-2048)
Fluid Capacity: 1200 ml (1.3 US qt)
1. Align a drain pan under the drain plug
106).
2. Remove the fill plug
Note:
Retain the fill plug and seal for installation
in step 6.
3. Remove the drain plug, and allow the fluid to
drain completely
Note:
Retain the drain plug for installation in
step 4.
4. Install the drain plug and torque it to 14 to 30
N∙m (10 to 22 ft-lb).
5. Fill the transaxle with the specified fluid and
capacity until it is even with the fill hole.
6. Install the fill plug and torque it to 14 to 30 N∙m
(10 to 22 ft-lb).
96
(Figure
(Figure 106).
(Figure 106).