Product Overview; Controls - Toro Workman UTX Operator's Manual

Product Overview

Controls

Become familiar with all the controls before you start the engine and operate the machine.
Control Panel
1. Headlight switch
2. Turn-signal switch
3. Hazard-light switch
Key Switch
Use the key switch (Figure
engine. To shut off the engine, rotate the key switch
counterclockwise to the O
The key switch has 3 positions: O
S . Rotate the key switch clockwise to the S
TART
position to engage the starter motor. Release the key
switch when the engine starts. The key switch moves
automatically to the O
Headlight Switch
Push the headlight switch
headlights or down to turn off the headlights.
4. Gear selector
5. Display
6. Differential-lock switch
61) to start and shut off the
position.
FF
, R , and
FF UN
position.
N
(Figure 61) up to turn on the
Figure 61
7. 2-wheel drive/4-wheel drive
switch
8. Cruise control switch
9. Horn switch
Turn-Signal Switch
Press the left side of the turn-signal switch
to activate the left-turn signal and the right side of the
switch to activate the right-turn signal.
Note:
The center position is off.
TART
Hazard-Light Switch
Press the hazard-light switch
the hazard lights or down to turn off the hazard lights.
52
10. USB power point
11. Key switch
(Figure
(Figure 61) up to turn on
g366070
61)