Table of Contents
Advertisement
Using the Cruise Control
In order to use cruise control, your seat belt must be
fastened, and you need to be driving at the following
ground speed based on your selected gear:
•
H (High Forward) gear—6 km/h (4 mph) or
greater
•
L (Low Forward) gear—3 km/h (2 mph) or greater
1.
Move the cruise control switch to the O
(Figure
71).
2.
When you reach the desired drive speed, press
the cruise control switch up to engage/set the
cruise control
(Figure
To increase the cruise control speed, press the
switch up until you reach the desired speed
(Figure
71).
Note:
Press the button 1 time to increase the
ground speed by an increment of 1 km/h (1
mph).
To disengage cruise control, press the switch to
the down, O
position
FF
Note:
When you press the brake pedal, the
cruise control disengages.
Figure 71
1. Set cruise control/increase
cruise speed
2. O
position
N
position
N
71).
(Figure
71).
g391453
3. O
positon
FF
Adjusting the Ground
Speed Governor
1.
Press and hold the button
10 seconds.
The set speed will blink.
2.
Press the button 1 time to increase the ground
speed by an increment of 1 km/h (1 mph).
Note:
The default maximum speed that you
can increase to is 40 km/h (25 mph).
If doors are installed on the machine, the
maximum ground speed that you can increase
to is 72 km/h (45 mph); the minimum is 8 km/h
(5 mph).
1. Button
Stopping the Machine
To stop the machine, remove your foot from the
accelerator pedal, then press the brake pedal.
Shutting Off the Engine
1.
Stop the machine.
2.
Shift the transmission lever to the P (P
position.
3.
Rotate the key switch to the O
remove the key.
66
(Figure
72) for at least
Figure 72
position and
FF
g367226
)
ARK
Advertisement
Table of Contents
