Toro Workman UTX Operator's Manual page 62

should use the handholds provided. Keep arms
and legs within the machine body at all times.
•
Operate the machine only in good visibility.
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could overturn the
machine. Tall grass can hide obstacles. Use care
when approaching blind corners, shrubs, trees, or
other objects that may obscure your vision.
•
Do not drive the machine near drop-offs, ditches,
or embankments. The machine could suddenly
roll over if a wheel goes over the edge or if the
edge gives way.
•
Always watch out for and avoid low overhangs
such as tree limbs, door jambs, overhead
walkways, etc.
•
Look behind and down before reversing the
machine to be sure of a clear path.
•
This machine was not designed or intended to
be used on public roadways. Doing so may be
hazardous and in violation of local laws.
•
When using the machine on public roads, follow
all traffic regulations and use any additional
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
signs, and others as required.
•
If the machine ever vibrates abnormally, stop
and shut off the machine immediately, wait for
all movement to stop, and inspect for damage.
Repair all damage to the machine before resuming
operation.
•
It can take longer to stop the machine on wet
surfaces than on dry surfaces. To dry out wet
brakes, drive slowly on a level surface while
putting light pressure on the brake pedal.
•
Operating the machine on a paved surface in
different modes, such as 2-wheel drive and
4-wheel drive, and carrying passengers and cargo
may affect the handling of the machine.
•
Operating the machine at high speed and then
quickly stopping may cause the rear wheels to lock
up, which impairs your control of the machine.
•
Improperly driving and/or making abrupt
maneuvers while driving at fast speed increases
the risk of a tip-over or rollover.
•
Do not touch the engine, transmission, muffler, or
exhaust manifold while the engine is running, or
soon after you shut off the engine, because these
areas may be hot enough to cause burns.
•
Do not leave a running machine unattended.
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission lever to the P (P
position.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Use accessories and attachments approved by
The Toro® Company only.
Rollover Protection System
(ROPS) Safety
•
The ROPS is an integral safety device. Do not
remove the ROPS from the machine.
•
Always wear your seat belt to prevent/minimize
injury to you and your passenger(s) in the event of
an accident; ensure that it is attached and that you
can release it quickly in an emergency.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace damaged ROPS components. Do not
repair or alter them.
Multi-Passenger Safety
•
Do not exceed the gross vehicle weight (GVW)
of the machine. You must account for yourself,
your passengers, and the load in the cargo bed
contributing to the overall GVW of the machine.
•
Passengers should sit in the designated seating
positions only. Do not allow passengers to sit in
the cargo bed.
•
You and your passengers should remain seated
with your seat belts secured whenever the
machine is in motion.
•
The additional machine length results in a larger
turn radius, so allow more space to maneuver the
machine.
Slope Safety
Slopes are a major factor related to loss-of-control
and tip-over accidents, which can result in severe
injury or death.
•
Survey the site to determine which slopes are
safe for operating the machine and establish your
own procedures and rules for operating on those
slopes. Always use common sense and good
judgment when performing this survey.
•
) If you feel uneasy operating the machine on a
ARK
slope, do not do it.
62