Checking The Front Differential Oil Level; Changing The Front Differential Oil - Toro Workman UTX Operator's Manual

Checking the Front
Differential Oil Level
Service Interval: Every 500 hours—Check the front
differential oil level.
Fluid Type: 80W-90 Gear Oil
1. Park the machine on a level surface.
2. Shift the transmission lever to the P (P
position.
3. Shut off the engine and remove the key.
4. Remove the check plug on the front differential
(Figure 107).
Note:
The oil level should be even with the
bottom of the check plug.
5. If the oil level is low, you may add the specified
oil through the check plug opening
6. Replace the check plug and torque it to 15 to
25 N∙m (11 to 18 ft-lb).
Figure 107
1. Fill plug
2. Check plug
)
ARK
(Figure 107).
g399038
3. Drain plug
Changing the Front
Differential Oil
Service Interval: Every 1,000 hours—Change the
front differential oil.
Fluid Type: 80W-90 Gear Oil
Fluid Capacity: 0.3 L (0.32 US qt)
1. Park the machine on a level surface.
2. Shift the transmission lever to the P (P
position.
3. Shut off the engine and remove the key.
4. Align a drain pan under the drain plug
107).
5. Remove the fill plug
Note:
Retain the fill plug and seal for installation
in step 9.
6. Remove the drain plug and allow the fluid to
drain completely
Note:
Retain the drain plug for installation in
step 7.
7. Install the drain plug and torque it to 15 to 25
N∙m (11 to 18 ft-lb).
8. Fill the front differential with the specified fluid
and capacity.
9. Install the fill plug and torque it to 15 to 25 N∙m
(11 to 18 ft-lb).
10. Allow the oil to settle for approximately 5
minutes, then check the level;
Front Differential Oil Level (page
97
ARK
(Figure
(Figure 107).
(Figure 107).
Checking the
97).
)