Toro Workman UTX Operator's Manual page 91

Gasoline utility vehicle
Hide thumbs Also See for Workman UTX:
Table of Contents

Advertisement

Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
• Keep sparks and flames away from the
battery.
• Never smoke near the battery.
Important:
Always keep the battery fully charged.
This is especially important to prevent battery
damage when the temperature is below 0°C (32°F).
1.
Remove the battery from the machine; refer to
Removing the Battery (page
2.
Connect a 3 to 4 A battery charger to the battery
posts. Charge the battery at a rate of 3 to 4 A
for 4 to 8 hours (12 V).
Note:
Do not overcharge the battery.
3.
Install the battery; refer to
(page
90).
Storing the Battery
If you store the machine for more than 30 days,
remove the battery and charge it fully. Either store
it on the shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery. To prevent
the battery from freezing, make sure it is fully charged.
89).
Installing the Battery
91

Advertisement

Table of Contents
loading

This manual is also suitable for:

0810008100tc08101

Table of Contents