Installing The Rollover Protection System; (Rops) - Toro Workman UTX Operator's Manual

7
Installing the Rollover
Protection System (ROPS)
For Crew (4-Person) Models
Parts needed for this procedure:
1 Left, front roll bar assembly
1 Right, front roll bar assembly
1 Left, rear roll bar assembly
1 Right, rear roll bar assembly
1 Left, middle roll bar assembly
1 Right, middle roll bar assembly
2 Roll bar connector assembly
1 Rear seat handle assembly
1 Front crosslink
1 Middle crosslink
1 Rear crosslink
2 Seat panel
4 Shoulder restraint
20 Hex-head bolt (3/8 x 1-1/4 inches)
16 Carriage bolt (5/16 x 3/4 inch)
8 Hex-washer head bolt (5/16 x 3/4 inch)
24 Hex-washer head bolt (1/4 x 3/4 inch)
2 Hex-washer head bolt (1/4 x 1 inch)
4
Button-head bolt (5/16 x 1-1/2 inches)
2 Flange-head bolt (3/8 x 2-1/4 inches)
4 Flange-head bolt (3/8 x 1 inch)
20 Locknut (5/16 inch)
26
Locknut (3/8 inch)
2 Locknut (1/4 inch)
4 Locknut (7/16 inch)
4 Clip (1/4 inch)
Procedure
1. Raise the cargo bed
31
(Figure 30).
Figure 30
g364836