Using Wi-Fi To Connect With Pc (Optional); Connect With Pc As Wi-Fi Access Point - Owon TAO 3000 Series Quick Manual

icon, click Utility. Select Function in the bottom menu. Select LAN Set in the left
menu. In the bottom menu, set the Type item as LAN, and select Set. In the right
menu, set IP and Port to the same value as the "Ports-settings" in the software in step
(3). The Gateway and Subnet mask should be set according to the router. Select Save
set in the bottom menu, it prompts "Reset to update the config". After resetting the
oscilloscope, if you can get data normally in the oscilloscope software, the connection
is successful.
Figure 4-7 Set the network parameters of the oscilloscope
Using Wi-Fi to Connect with PC

Connect with PC as Wi-Fi Access Point

PC should support Wi-Fi.
(1) Set the oscilloscope. In the oscilloscope, click the
Function in the bottom menu. Select LAN Set in the left menu. In the bottom menu,
set the Type item as WIFI-AP, and select Set in the bottom menu.
(2) In the right menu, select SSID, a keyboard will pop up. You can turn and push the M
knob, or touch the keyboard (if the LCD is touchscreen) to set the access point name.
(3) In the right menu, select Encryption, push again to set the type. Open type needs no
password. WEP or WPA type need to set the password. You can select WPA. In the
right menu, select Password, use the keyboard to set the WI-FI password (8 to 32
characters).
(4) In the right menu, select IP:PORT, IP is fixed by the oscilloscope, and can not be
edited. Here IP is 192.168.1.1. Turn the M knob to set the PORT. Here, we set it to
3000.
(5) After setting, select ON in the Status menu. The
the screen.
4.Communication with PC
(Optional)
25
icon, click Utility. Select
icon appears on the top right of