YOKOGAWA WT332E User Manual page 42

2.3 Connecting the Power Supply
Connecting the Power Cord
1. Check that the instrument's power switch is off.
2. Connect the power cord plug to the power inlet on the rear panel of the instrument.
3.
Connect the other end of the cord to an outlet that meets the following conditions. Use a
grounded three-prong outlet.
Item
Rated supply voltage
Permitted supply voltage range
Rated power supply frequency
Permitted supply frequency range
Maximum power consumption
* This instrument can use a 100 V or a 200 V power supply. The maximum rated voltage differs according
2-8
to the type of power cord. Check that the voltage supplied to the instrument is less than or equal to the
maximum rated voltage of the power cord that you will be using before use.
WT310E/WT310EH
Specification
100 VAC to 120 VAC, 200 VAC to 240 VAC
90 VAC to 132 VAC, 180 VAC to 264 VAC
50/60 Hz
48 Hz to 63 Hz
WT310E/WT310EH: 50 VA, WT332E/WT333E: 70 VA
WT332E/WT333E
Three-prong outlet
IM WT310E-02EN