YOKOGAWA WT332E User Manual page 40

2.2 Installing the Instrument
Rubber Feet
If the instrument is installed so that it is flat as shown in the above figure, rubber stoppers can be
attached to the feet to prevent the instrument from sliding. One set of rubber stoppers (two stoppers)
are included in the package.
Rack Mounting
To mount the instrument on a rack, use a rack mount kit (sold separately).
• For the WT310E/WT310EH
Item
Rack mount kit
Rack mount kit
Rack mount kit
Rack mount kit
• For the WT332E/WT333E
Item
Rack mount kit
Rack mount kit
Rack mount kit
Rack mount kit
A summary of the procedure for mounting the instrument on a rack is given below. For detailed
instructions, see the manual that is included with the rack mount kit.
1. Remove the handle from the instrument.
•
•
For detailed instructions for the procedures below, see the manual that is included with the rack mount kit.
2.
Remove the feet from the bottom of the instrument.
3.
Peel off the seals over the rack mount attachment holes on both side panels of the instrument,
and pull out the rubber rivets.
4. Place seals over the feet and handle attachment holes.
5. Attach the rack mount kit to the instrument.
6. Mount the instrument on a rack.
Note
• When rack-mounting the instrument, allow at least 20 mm of space around the inlet and exhaust holes to
prevent internal heating.
• Make sure to provide adequate support from the bottom of the instrument. The support should not block the
inlet and vent holes.
2-6
Model
751533-E2
751533-J2
751534-E2
751534-J2
Model
751533-E3
751533-J3
751534-E3
751534-J3
WT310E/WT310EH
Rotate the handle to position 8 (see the figure on the previous page), and then pull out the rotating base
of the handle by approximately 10 mm on both sides.
WT332E/WT333E
Remove the handle attachment section cover, and remove the handle attachment screws.
WT310E/WT310EH
To remove the handle, rotate
the handle to position 8, and
then pull out the rotating base
Rotating base
of the handle by approximately
10 mm on both sides.
Note
For EIA single mount
For JIS single mount
For EIA dual mount
For JIS dual mount
Note
For EIA single mount
For JIS single mount
For EIA dual mount
For JIS dual mount
WT332E/WT333E
Cover
Handle
Cover
IM WT310E-02EN