How To Measure Automatically - Owon SDS5052E-V User Manual

● LAN Set
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in the menu below.
Refer to "Using LAN Port" on P82 for the operation steps.
Press the Utility button and turn the M knob to select the LAN Set to go to the following
menu.
The description of LAN Set menu is shown as the follows:
Function
Setting
Menu
IP
Port
Netgate
Set
Phy addr
Net mask
Save set Save the current settings and prompt "reset to update the config"

How to Measure Automatically

Press the Measure button to display the menu for the settings of the Automatic
Measurements. At most 8 types of measurements could be displayed on the bottom left
of the screen.
The oscilloscopes provide 24 parameters for auto measurement, including Period, Freq,
Mean, PK-PK, RMS, Max, Min, Vtop, Vbase, Vamp, OverShoot, PreShoot, Rise Time,
Fall Time, +D width, -D width, +Duty, -Duty, Delay A→B , Delay A→B , Cycle
RMS, Cursor RMS, Duty cycle, and Phase.
The menu is displayed as Figure 5-67.
5.Advanced User Guidebook
Figure 5-66 LAN Set menu
Description
Press F1 button to switch between each byte, turn the M knob
to change value (0 - 255)
Turn the M knob to change value (0 - 4000)
Press F3 button to switch between each byte, turn the M knob
to change value (0 - 255)
Press F4 button to switch between each byte, turn the M knob
to change value (0 - FF)
Press F5 button to switch between each byte, turn the M knob
to change value (0 - 255)
68