Table of Contents
Advertisement
Projecting
Check the external device connection (x page 42) and the power cord connection (x page 49), and turn on
the power (x page 52) to start projection. Select the image to project, and adjust appearance of the projected
image.
Selecting the input signal
The input of the image to project can be switched. Method to switch the input is as follows.
f Press the input selection button on the remote control and directly specify the input of the image to project.
f Press the <输入信号选择> button on the control panel to display the input selection screen, and select the input
to project from the list.
Switching the input directly with the remote control
The input of the image to project can be switched by directly specifying it with the input selection button on the
remote control.
1)
Press the input selection button (<RGB1/2>, <DIGITAL LINK>, <DVI-D>, <SDI>, <HDMI>).
<RGB1/2>
<DIGITAL LINK>
<DVI-D>
<SDI>
<HDMI>
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back.
Set the [PICTURE] menu → [SYSTEM SELECTOR]. When the SDI signal is input, set the [DISPLAY OPTION] menu → [SDI 输入].
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100C) is connected to the <DIGITAL LINK> terminal, the
input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input can also be
changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
62 - ENGLISH
Chapter 3 Basic Operations — Projecting
Remote control
Switches the input to RGB.
The image of the signal input to the <RGB 输入> terminal is projected.
Switches the input to DIGITAL LINK.
The image of the signal input to the <DIGITAL LINK> terminal is projected.
Switches the input to DVI-D.
The image of the signal input to the <DVI-D 输入> terminal is projected.
Switches the input to SDI.
The image of the signal input to the <SDI 输入> terminal is projected.
Switches the input to HDMI.
The image of the signal input to the <HDMI 输入> terminal is projected.
Control panel
Advertisement
Table of Contents
