Advertisement
Network Deployment
General Connection (without PoE)
1. Connect RJ45 Ethernet cable to a switch. Use a Category 5 Cross Cable when your network
camera is directly connected to PC.
2. Connect the power cable from the Network Camera to a power outlet.
Power over Ethernet (PoE)
The Network Camera is PoE-compliant, allowing transmission of power and data via a single
Ethernet cable. Follow the above illustration to connect the Network Camera to a PoE-enabled switch
via Ethernet cable.
Assigning an IP Address
You must know the IP address of
IP Camera before you can
connect to it. The IP Camera
will use DHCP server on your
local network to obtain an IP
address automatically by default.
So, you can check your DHCP
server's IP address lease table to
find the IP address of IP Camera
6
Advertisement
