Table of Contents
Advertisement
Chapter 6 Operations and Measurements
or enable the touch screen to select the channel. The available channels for
Source A and Source B are CH1-CH4 and Ref1-Ref10.
Note:
The available channels for Math2 are CH1-CH4, Ref1-Ref10 or Math1.
The available channels for Math3 are CH1-CH4, Ref1-Ref10, Math1 or Math2.
The available channels for Math4 are CH1-CH4, Ref1-Ref10, Math1, Math2 or
Math3. Only the channels that have been enabled currently can be selected.
Press Offset to set the vertical offset of the operation results. For setting
⚫
methods, refer to the descriptions in "Parameter Setting Method". You can
also enable the touch screen and use the "Drag" gesture to adjust the vertical
offset.
Press Scale to set the vertical scale of the operation results. For setting methods,
⚫
refer to the descriptions in "Parameter Setting Method". You can also enable
the touch screen and use the "Pinch & Stretch" gesture to adjust the vertical
scale.
Press More → AutoSetting to adjust the vertical scale and the offset of the
⚫
operation results to the optimal value according to the current configuration, so
as to better to observe.
Press More → Invert to enable or disable the inverted display function of the
⚫
waveform.
Press More → Expand to expand or compress the math operation waveform
⚫
around the "Center" or "GND".
Press More → Label to set the label for math operation results. For details,
⚫
refer to descriptions in "Math Operation Label".
Press More → Color Grade to enable or disable the color grade display of the
⚫
operation results. When enabled, different colors are displayed on the screen to
indicate the times of data acquisition or acquisition probability.
Press More → Reset ColorGrade to clear the color grade display and display
⚫
the color grade again.
Subtraction
Subtracts the waveform voltage values of signal source B from that of source A point
by point and displays the results.
Press Math → Math1 → Operator to select "A-B":
Press Operation continuously to enable or disable the subtraction operation
⚫
function.
Press SourceA and SourceB respectively, and rotate the multifunction knob
⚫
to select the channel for Source A and Source B. Then press down the knob
to select the channel. You can also press SourceA and SourceB continuously
or enable the touch screen to select the channel. The available channels for
Source A and Source B are CH1-CH4 and Ref1-Ref10.
MSO5000 User Guide
RIGOL
6-3
Advertisement
Table of Contents
