Table of Contents
Advertisement
Chapter 3 To Set the Horizontal System
Waveform before enlargement:
The waveform in the area that is not covered by subtransparent blue in the upper
part of the screen is the waveform before enlargement. Its horizontal time base (also
called main time base) is displayed at the upper-left corner of the screen. You can
rotate the Horizontal
the Horizontal
Note:
If you need to modify the horizontal time base (also called main time base) of
the normal sweep, please disable the delayed sweep function first. Rotate the
Horizontal
enable the delayed sweep function.
Waveform after enlargement:
The waveform in the lower part of the screen is the horizontally expanded delayed
sweep waveform. Its horizontal time base (also called the time base of the delayed
sweep) is displayed on the screen. Compared with the main time base, the time
based of the delayed sweep has increased the waveform resolution, as shown in
Figure 3-1. At this time, you can rotate the Horizontal
the time base of the delayed sweep, and rotate the Horizontal
knob to adjust the horizontal position of the delayed sweep.
Note:
The time base of the delayed sweep should be smaller than or equal to the
main time base.
MSO5000 User Guide
POSITION knob to move the area left and right or rotate
SCALE knob to enlarge or reduce this area.
SCALE knob to set the required main time base, and then
RIGOL
SCALE knob to adjust
POSITION
3-5
Advertisement
Table of Contents
