Firmware Compatibility; Restoring The Delivery State - Beckhoff EL3783 Documentation

7.2

Firmware compatibility

Beckhoff EtherCAT devices are delivered with the latest available firmware version. Compatibility of firmware
and hardware is mandatory; not every combination ensures compatibility. The overview below shows the
hardware versions on which a firmware can be operated.
Note
• It is recommended to use the newest possible firmware for the respective hardware.
• Beckhoff is not under any obligation to provide customers with free firmware updates for delivered
products.
Risk of damage to the device!
Pay attention to the instructions for firmware updates on the separate page [} 170]. If a device is placed in
BOOTSTRAP mode for a firmware update, it does not check when downloading whether the new firmware
is suitable. This can result in damage to the device! Therefore, always make sure that the firmware is suit-
able for the hardware version!
EL3783
Hardware (HW) Firmware (FW)
00 - 01 01
02
02 - 03 03
04
05
06
03* 07*
*) This is the current compatible firmware/hardware version at the time of the preparing this documentation.
Check on the Beckhoff web page whether more up-to-date documentation is available.
Note on EL3783 firmware update
Secondary voltage necessary for firmware updates
In order to change the firmware of the EL3783, the permissible operating voltages must be applied
both to the fieldbus side (E-Bus) and to the load side (power contacts), otherwise the terminal re-
mains in INIT_ERROR or cannot be switched to BOOTSTRAP mode.
7.3

Restoring the delivery state

To restore the delivery state for backup objects in ELxxxx terminals, the CoE object Restore default
parameters, SubIndex 001 can be selected in the TwinCAT System Manager (Config mode) (see Fig.
Selecting the Restore default parameters PDO)
EL3783
NOTE
Revision no.
EL3783-0000-0016
EL3783-0000-0018
Version: 1.1
Appendix
Release date
2016/02
2016/04
2016/10
2017/02
2017/02
2017/06
181