Kyocera Mita KM-2560 Service Manual page 90

2H0/2HZ
Maintenance
item No.
Setting the limit for the ejection section of the built-in finisher
U236
Description
If the machine is equipped with an optional built-in finisher, this mode sets whether A5R/B5R/statement size
paper is output to the machine eject tray or not.
Purpose
If the machine is equipped with an optional built-in finisher and if paper jams occur due to curling of paper in
the built-in ejection section when two-sided copying onto A5R/B5R/statement size paper is performed, this
mode is used to change the setting to ON to disable ejection to the machine eject tray.
Setting
1. Press the start key.
2. Select ON or OFF.
Display
ON
OFF
Initial setting: OFF
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking the operation of the DP motors
U243
Description
Turns the motors and solenoids in the optional DP on.
Purpose
To check the operation of the DP motors or solenoids.
Method
1. Press the start key.
2. Select the item to be operated.
3. Press the start key. The operation starts.
Display
DP FEED MOTOR
DP CONV MOTOR
DP REV MOTOR
DP RJ SOL
DP RP SOL
4. To stop operation, press the stop key.
Completion
Press the stop key when operation stops. The screen for selecting a maintenance item No. is displayed.
1-3-54
Description
Description
Does not eject to the machine eject tray.
Eject to the machine eject tray.
Motors and solenoids
Original feed motor (OFM) is turned on.
Original conveying motor (OCM) is turned on.
Original switchback motor (OSBM) is turned on.
Switchback feedshift solenoid (SBFSSOL) is turned on.
Switchback pressure solenoid (SBPSOL) is turned on.