Kyocera Mita KM-2560 Service Manual page 139

Section Description
Optional 81
finisher Paper entry sensor
nonarrival jam
82
Jam in stapler
83
Exit sensor stay jam
91
Finisher cover open
(document finisher
only)
92
Exit sensor non-arrival
jam (document finisher
only)
93
Reverse sensor jam
(document finisher
only)
Conditions
(Document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(Built-in finisher)
The paper conveying switch (PCSW) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the process table from the paper conveying unit.
(Document finisher)
The staple home position sensor (STSPS) is not turned
on within the specified time when driving the staple motor
(STM).
(Built-in finisher)
The staple home position sensor (STHPS) is not turned
on within the specified time when driving the staple motor
(STM).
(Document finisher)
In the straight mode, the exit sensor (EXS) is not turned
off within specified time of its turning on.
(Document finisher)
In the offset or staple mode, the exit sensor (EXS) is not
turned off within specified time of its turning on.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is
ejected to the finisher tray from the process table.
The finisher cover becomes open during paper is run-
ning.
Paper is remaining in paths at power on.
In the straight mode, the exit sensor (EXS) is not turned
on even if a specified time has elapsed after the paper
entry sensor (PES) was turned on.
The reverse sensor (REVS) does not turn on within spec-
ified time of paper entry sensor (PES) turning on.
The reverse sensor (REVS) is not turned on within speci-
fied time.
The reverse sensor (REVS) does not turn off within spec-
ified time of paper entry sensor (PES) turning off.
The reverse sensor (REVS) is not turned off within speci-
fied time its turning on.
2H0/2HZ
Specified time
2627 ms
2000 ms
1429 ms + Paper
length
1000 ms
600 ms
1680 ms
5375 ms
1429 ms + Paper
length
-
1770 ms
1125 ms
Depends on paper
size
654 ms
Depends on paper
size
1-4-7