Kyocera Mita KM-2560 Service Manual page 145

Problem Causes/check procedures
(15) Broken feedshift switch or
A paper jam in the job separator eject switch
eject section is indi- actuator.
cated during copying
Defective switch.
(jam in optional job
separator eject sec-
tion).
Jam code 51
(16) Check if the feedshift sole-
A paper jam in the noid malfunctions.
feedshift section is
indicated during
Electrical problem with the
copying (jam in feed-
feedshift solenoid.
shift section).
Jam code 52
Broken feedshift switch
actuator.
Defective switch.
Check if the registration
clutch malfunctions.
Electrical problem with the
registration clutch.
(17) Broken feedshift switch or
A paper jam in the duplex paper conveying
duplex section is indi- switch actuator.
cated during copying
Defective switch.
(jam in duplex paper
conveying section 1).
Jam code 60
(18) Broken duplex paper con-
A paper jam in the veying switch or registration
duplex section is indi- switch actuator.
cated during copying
Defective switch.
(jam in duplex paper
conveying section 2).
Jam code 61
Corrective measures
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Feedshift switch, job separator eject switch
Run maintenance item U033 and select the feedshift solenoid on
the touch panel to be turned on and off. Check the status and rem-
edy if necessary.
Check (see page 1-4-40).
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Feedshift switch
Run maintenance item U032 and select the registration clutch on
the touch panel to be turned on and off. Check the status and rem-
edy if necessary.
Check (see page 1-4-39).
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Feedshift switch, duplex paper conveying switch
Check visually and replace switch.
Run maintenance item U031 and turn switch on and off manually.
Replace the switch if indication of the corresponding switch on the
touch panel is not displayed in reverse.
Duplex paper conveying switch, registration switch
2H0/2HZ
1-4-13