Network Setup - Kyocera 1102H03NL0 Advanced Operation Manual

System Menu

Network Setup

TCP/IP Setup (by Entering IP Addresses)
6-56
The machine is equipped with network interface, which is compatible with
network protocols such as TCP/IP, IPX/SPX, NetBEUI, and AppleTalk. It
enables network printing on the Windows, Macintosh, UNIX, NetWare and
other platforms.
Set up TCP/IP to connect to the Windows network. Set the IP addresses,
subnet masks, and gateway addresses.
NOTE:
Prior to the IP address entries, obtain permission from the
network administrator.
Use the procedure below to specify the TCP/IP settings.
1
Press the System Menu key.
2 Press [System], [Next] of Network and then [Change] of TCP/IP.
3 Press [On] on the
left side of the touch
panel.
4 Press [Off] of DHCP.
5
Press [IP Address]
and enter the
address using the
numeric keys.
6
Press [Subnet Mask] and enter the address using the numeric keys.
7 Press [Default Gateway] and enter the address using the numeric keys.
System - TCP/IP
Use TCP/IP.
DHCP
Off
On
On
Off IP Address
Subnet Mask
Default
Gateway
Status
System - TCP/IP
Use TCP/IP.
DHCP
Off
On
On
Off IP Address
Subnet Mask
Default
Gateway
Status
ADVANCED OPERATION GUIDE
0.0.0.0
0.0.0.0
0.0.0.0
Cancel OK
10/10/2007 10 :10
192.168.1.150
0.0.0.0
0.0.0.0
Cancel OK
10/10/2007 10 :10