Program (Copying And Sending) - Kyocera 1102H03NL0 Advanced Operation Manual

Program (Copying and Sending)

Registering Programs
Recalling Programs
ADVANCED OPERATION GUIDE
After registering sets of frequently used functions as a single program, you
can simply press the program number as needed to recall those functions.
You can also name the programs for easy identification when recalling.
NOTE:
Sending operation can be registered in the program as well. Up
to 50 functions combining copying and sending can be registered in the
program.
If user login is enabled, you can only register functions by logging in with
administrator privileges.
Use the procedure below to register a program.
The following procedure is an example of registering the copying function.
1
Press the Program key while the copy mode is accessed.
2 Press [Register] and press a number (01 to 50) for the program number.
If entering Program screen from the Copy screen or Send screen, go to
step 4.
NOTE:
If you select a program number already registered, the currently
registered functions can be replaced with a new set of functions.
3 Check that [Copy] is selected, and press [Next].
4
Enter the new program name and press [Register] to register the program.
Use the procedure below to recall a registered program.
1 Press the Program key.
2 Press [Call] and
press the key
corresponding to the
program number (01
to 50) to recall.
Press [No.] to enter
the program number
directly for recalling.
Program
01
06
02 07
03 08
04 09
05
10
Call Register Edit
Status
Copying Functions
1
No.
10/10/2007 10 :10
1-57