Kyocera 1102H03NL0 Advanced Operation Manual page 239

Auto Color Correction
ADVANCED OPERATION GUIDE
3
Press [Off] or [On].
4
Press [OK].
This setting allows you to adjust the detection level used by the machine
to determine whether the original is color or monochrome during sending.
Setting a lower value will result in more originals being identified as color,
while a larger value will tend to increase the number of originals being
identified as monochrome.
NOTE:
Regardless of whether the PDF upgrade kit is installed, this
option is only displayed if at least 1 GB of memory has been installed.
Use the procedure below to set the Auto Color Detection Level.
1 Press the System Menu key.
2
Press [ ] > [Adjustment/Maintenance] > [Change] in Auto Color
Correction.
3 Press one of keys [1] to [5] to set the detection level.
4
Press [OK].
Adjustment /Maintenance - Silent Mode
Make after-printing process run more quietly.
*This may increase the time need to prepare
for the next job.
On
Off
Status
Adjustment /Maintenance - Auto Color Correction
Adjust the auto color correction.
Color
1 2 3
Status
System Menu
Cancel OK
10/10/2007 10 :10
Monochrome
4 5
Cancel OK
10/10/2007 10 :10
6-69
6