Jumper Settings; At/Atx Power Mode Select Jumper; Table 4-28: Jumpers - IEI Technology ECN-360A-HM65 User Manual

ECN-360A-HM65 Em b e d d e d S ys te m
4.4 J u m p e r S e ttin g s
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.
The jumpers on the motherboard are listed in Table 4-28.
De s c rip tio n
AT/ATX power mode select
Clear CMOS
LVDS voltage select
LVDS panel resolution select
TPM setting
Flash descriptor security override

Table 4-28: Jumpers

4.4.1 AT/ATX P owe r Mo d e S e le c t J u m p e r
J u m p e r La b e l:
J u m p e r Typ e :
J u m p e r S e ttin g s :
J u m p e r Lo c a tio n :
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.
La b e l
J_ATXCTL1
J_CMOS1
J_VLVDS1
J_PID1
ME_RTC1
J_FLASH1
J _ATXCTL1
3-pin header
See Table 4-29
See Figure 4-24
Typ e
3-pin header
3-pin header
3-pin header
8-pin header
3-pin header
3-pin header
P a g e 49