Anti - Static Precautions; Unpacking Precautions - IEI Technology ECN-360A-HM65 User Manual

ECN-360A-HM65 Em b e d d e d S ys te m
2.1 An ti-s ta tic P re c a u tio n s
WARNING:
Failure to take ESD precautions during installation may result in
permanent damage to the ECN-360A-HM65 and severe injury to the
user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the ECN-360A-HM65. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the ECN-360A-HM65 or any other electrical component is
handled, the following anti-static precautions are strictly adhered to.

Wear an anti-static wristband: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.

Self-grounding: Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.

Use an anti-static pad: When configuring the ECN-360A-HM65, place it on
an antic-static pad. This reduces the possibility of ESD damaging the
ECN-360A-HM65.
2.2 Un pa c kin g P re c a u tio n s
When the ECN-360A-HM65 is unpacked, please do the following:

Follow the anti-static precautions outlined in Section 2.1.

Make sure the packing box is facing upwards so the ECN-360A-HM65 does
not fall out of the box.

Make sure all the components shown in Section 2.3 are present.
P a g e 9