Flash Off Time - Datalogic QuickScan QD24 Series Product Reference Manual

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3. Go to page 81
ming Mode.
4. Scan the bar code: SELECT FLASH OFF TIME SETTING.
5. Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 42. Flash Off Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
leading zeroes to yield two
2
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH OFF TIME SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 42
EXAMPLES
'0' and '5'
Appendix D,
for some examples of how to set this feature.
500ms 1,000ms (1 sec.) 5200ms (5.2 sec.)
05 10
'1' and '0'
Scanning Features
Keypad, that represent the
9,900ms (9.9 sec.)
52 99
'5' and '2' '9' and '9'
259