Character Conversion - Datalogic QuickScan QD24 Series Product Reference Manual

References

Character Conversion

Character conversion is an eight byte configuration item. The eight bytes are 4 character pairs
represented in hexadecimal ASCII values. The first character in the pair is the character that will
be converted. The second character in the pair is the character to convert to. If the character to
convert in a pair is FF, then no conversion is done.
For example, if you have the character conversion configuration item set to the following:
41423132FFFFFFFF
The first pair is 4142 or AB (41 hex is an ASCII capital A, 42 hex is an ASCII capital B) and the
second pair is 3132 or 12 (31 hex is an ASCII 1, 32 is an ASCII 2). The other two pairs are FFFF
and FFFF.
With the label, AB12BA21, it would look as follows after the character conversion: BB22BB22.
The A characters were converted to B characters and the 1 characters were converted to 2 char-
acters. Nothing is done with the last two character pairs, since they are all FF.
To set Character Conversion:
1. Go to page 66
2. Scan the "Configure Character Conversion" bar code.
3. Determine the desired string. Sixteen positions must be determined as in the above exam-
ple. Next, turn to the
equivalent hex digits needed to fulfill the string.
4. Turn to Appendix D, Keypad
determined in the previous step.
5. Scan the ENTER/EXIT bar code to exit Programming Mode.
If less than the expected string of 16 characters are selected, scan the ENTER/EXIT bar
code twice to accept the selections and exit Programming Mode.
NOTE
252
and scan the ENTER/EXIT bar code.
ASCII Chart on the inside back cover of this manual and find the
and scan the bar codes representing the hex characters
QuickScan™ I QD24XX/QBT24XX/QM24XX