Setting The Interface - Datalogic QuickScan QD24 Series Product Reference Manual

Setup

Setting the Interface

Scan the programming bar code from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding sec-
tion in this manual (also listed in
tures associated with that interface.
Unlike some programming features and options, interface selections require that
you scan only one programming bar code label. DO NOT scan an ENTER/EXIT bar
code prior to scanning an interface selection bar code.
NOTE
Some interfaces require the scanner to start in the disabled state when powered up.
If additional scanner configuration is desired while in this state, pull the trigger and
hold it for five seconds. The scanner will change to a state that allows programming
with bar codes.
Table 1. Available Interfaces
RS-232
RS-232 standard interface
$P,HA12,P(CR)
Select RS232-WN
RS-232 for use with OPOS/UPOS/JavaPOS
$P,HA47,P(CR)
Select USB-COM-STD
USB-OEM
$P,HA45,P(CR)
Select USB-OEM
a. Download the correct USB Com driver from www.datalogic.com
18
Table 1 on page
$P,HA13,P(CR)
USB Com to simulate RS-232 standard interface
a
(can be used for OPOS/UPOS/JavaPOS)
18) to configure any desired settings and fea-
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS-232 OPOS
USB-OEM
QuickScan™ I QD24XX/QBT24XX/QM24XX
FEATURES
Set RS-232
Interface
Features
starting on
page 27
FEATURES
Set USB-OEM
Interface
Features
starting on
page 49