Table of Contents
Advertisement
⑥ Setting the tally lamp indication
Set any of the following display modes of the tally
lamps located at the top of the front of the monitor.
• R/G : R is on the left side and G on the right
side, when facing the screen.
R
G
[R-TALLY ON]
[G-TALLY ON]
• G/R : G is on the left side and R on the right
side, when facing the screen.
G
R
[G-TALLY ON]
[R-TALLY ON]
• R+G : The entire tally is displayed.
The lamp is displayed in amber when both
the R-TALLY and G-TALLY are set at ON.
Both R- and G-TALLY at ON.
← [ R-TALLY ON]
R
G
← [ G-TALLY ON]
AMBER
← [ Both R- and G-TALLY at ON]
• Default setting is R/G.
⑦ Setting the same-size (dot-by-dot) display ON/OFF
Set to ON in order to reproduce the input signal
in its original pixels without enlargement or
reduction.
This function can be assigned with the F1 F2
switch on the front panel.
• Default setting is OFF.
* Signals in 480i/575i format are not in square
pixels. Therefore, the aspect ratio will be displayed
differently from the original image.
⑧ Setting the SDI channel switching lock ON/OFF
The lock is set to "ON" to prevent SDI signal
channel switching.
It utilizes the MONITOR OUT terminal and is
effective in fixing the channel. It prevents
accidental channel switching.
• Default setting is OFF.
* Before setting it to "ON", make sure the desired
SDI channel is selected.
⑨ Setting the format display ON/OFF before switching
signals
Used to set whether the channel and signal
format are displayed or not.
• Default setting is ON.
- 17 -
Advertisement
Table of Contents
