Changing Hydraulic Tank Oil - Kubota RTV-X900G Operator's Manual

84 PERIODIC SERVICE
BChanging Hydraulic Tank Oil
To avoid serious injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a level surface.
2. Open the seat.
3. Remove the rubber cap.
4. To drain the used oil, remove the drain plug and filling
plug and drain the oil completely into the oil pan.
5. After draining, reinstall the drain plug.
6. Fill with new KUBOTA UDT or SUPER UDT fluid up to
the upper line on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
How to check:
Wipe dipstick clean with a rag and screw it into filling
hole. Remove dipstick again to see if the oil level is
between the upper and lower line.
7. After filling, reinstall the filling plug.
8. Properly dispose of used oil.
Oil Capacity
(1) Drain plug
(1) Filling plug with dipstick
18.0 L
(A) Oil level is acceptable within
this range