Replacing Transmission Oil Filter [Suction]; Changing Hydraulic Tank Oil - Kubota RTV1140 CPX Operator's Manual

Table of Contents

Advertisement

BReplacing Transmission Oil Filter
[SUCTION]
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface, raise the cargo bed,
and mount the safety support.
2. Remove the rear guard and hose guard.
3. Remove the oil filters.
4. Put a film of clean transmission oil on the rubber seal
of the new filter.
5. Quickly tighten the filter until it contacts the mounting
surface, then, with a filter wrench, tighten it an
additional 1 turn only.
6. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
7. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
8. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
9. Install the rear guard, and the hose guard.
(1) Transmission oil filter (Suction) (Orange color)
(2) Rear guard
(3) Hose guard
A To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.
BChanging Hydraulic Tank Oil
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a firm, flat and level surface.
2. Tilt the seat.
3. Remove the under guard.
4. To drain the used oil, remove the drain plug and filling
plug and drain the oil completely into the oil pan.
5. After draining, reinstall the drain plug.
6. Install the under guard.
7. Fill with new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
How to check:
Wipe dipstick clean with a rag and screw it into filling
hole. Remove dipstick again to see if the oil level is
between the upper and lower notch.
8. After filling, reinstall the filling plug.
Oil Capacity
(1) Under guard
PERIODIC SERVICE
14.5 L (15.3 U.S.qts.)
63

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents