Setting A Connected Computer's Resolution And Refresh Rate - SMART Board 6075S Installation And Maintenance Manual

Chapter 3
Connecting computers and other devices
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap the Home button
and then tap Input
OR
Press the Input button
The display shows thumbnails of the devices that are connected to the display:
A gray thumbnail indicates no device is connected to an input.
o
A blue thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an input.
o
TIP
If iQ is disabled and you want a computer's input to appear whenever you wake up the display, tap
the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.

Setting a connected computer's resolution and refresh rate

This table presents the recommend resolutions and refresh rates for the display's inputs:
Input source
HDMI 1
HDMI 2
HDMI 3
VGA
If possible, set connected computers to these resolutions and refresh rates. See the computers' operating
system documentation for instructions.
smarttech.com/kb/171414
below the screen,
.
on the remote control.
Resolution
3840 × 2160
3840 × 2160
3840 × 2160
1920 × 1080
If iQ is disabled
Tap the Home button
OR
Press the Home button
on the remote control.
Refresh rate
60 Hz
60 Hz
60 Hz
60 Hz
below the screen.
or the Input button
33