SMART Board 6075S Installation And Maintenance Manual page 71

Appendix B
Managing the display using RS-232
NOTES
Use ASCII formatted commands.
l
Commands aren't case-sensitive and extra spacing is ignored.
l
You can use the BACKSPACE key when typing commands.
l
Review each entry carefully before you press ENTER.
l
Don't send another command until you receive the response and the next command prompt.
l
To retrieve a setting's current value
Use a get command.
This example shows how to get the volume:
>get volume
volume=55
>
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65
>
smarttech.com/kb/171414 70