Mute Commands; Firmware Version Commands; Serial Number Commands; Part Number Commands - SMART Board 6075S Installation And Maintenance Manual

Appendix B
Managing the display using RS-232

Mute commands

Get command
get mute

Firmware version commands

Get command
If one display is connected
get fwversion
If multiple displays are connected
[Display],@ get fwversion
Where [Display] is the display's label (A, B, and so on).

Serial number commands

Get command
get serialnum
smarttech.com/kb/171414
Set command
set mute[Value]
Where [Value] is one of the following:
=on
l
=off
l
Response
fwversion=[Value]
Where [Value] is the firmware version.
@,[Display] fwverversion=[Value]
Where
[Display] is the display's label (A, B, and so on).
l
[Value] is the firmware version.
l
Response
serialnum=[Value]
Where [Value] is the serial number.
NOTE
If multiple displays are connected, the response includes the
serial numbers for all displays separated by commas.
Response
mute=[Value]
Where [Value] is one of the following:
on
l
off
l
74