Installing The Display On A Wall; Dealing With Cracked, Chipped Or Shattered Glass; Saving The Original Packaging - SMART Board 6075S Installation And Maintenance Manual

Hide thumbs

Table of Contents

Chapter 2

Installing the display

Dealing with cracked, chipped or shattered glass

The display contains safety-tempered glass. Although this glass is heat-strengthened to help withstand

impacts, the glass can crack, chip or shatter if struck with enough force. (Safety glass is designed to break

into small pieces rather than sharp shards if it is broken.) Temperature changes can cause a minor crack or

chip to become worse, possibly causing the glass to shatter. See the knowledge base article,

glass on an interactive

display, for information about conditions that can cause the display's glass to shatter

even when it's not in use.

If the display's glass is cracked or chipped, have it professionally inspected and repaired at a SMART

authorized repair center. If the display's glass shatters, carefully clean up the area and have the display

repaired or replaced.

CAUTION

For safety and to prevent further damage, do not continue to install or use the display if its glass is

cracked, chipped or shattered.

Saving the original packaging

Save the original packaging and repack the display with as much of it as possible if you ever need to move

the display after installation. This packaging was designed to provide the best possible protection against

shock and vibration.

CAUTION

Move the display only in the original packaging or replacement packaging purchased from your

authorized SMART reseller. Moving the display without correct packaging can lead to product damage

and voids the warranty.

NOTE

If the original packaging isn't available, you can purchase the same packaging directly from your

authorized SMART reseller (smarttech.com/where).