CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES
Setting a connected computer's resolution and refresh rate
The following table presents the recommend resolutions and refresh rates for the display's input
sources:
Input source
HDMI 1
HDMI 2
HDMI 3
VGA
If possible, set any connected computers to these resolutions and refresh rates. See the
connected computers' operating system documentation for instructions.
Connecting USB drives, peripherals, and other devices
You can use USB drives, peripherals, and other devices with a computer connected to the display
using the USB receptacles on the display.
For more information, see Connecting USB drives, peripherals, and other devices on page 33.
Troubleshooting connected computers
For troubleshooting information for connected computers, see Chapter 5: Troubleshooting on
page 35.
Connecting a SMART OPS PC module
If your organization has purchased a SMART OPS PC module, you or
your organization's installers can install the OPS PC module in the
accessory slot of the SMART Board 6000S or 6000S Pro series
interactive display following the OPS PC module's installation
instructions (smarttech.com/kb/171544). You can then view the OPS PC
module's input on the display.
For more information about the PCM8 series of SMART OPS PC
modules, see SMART OPS PC module on page 8.
CAUTION
Do not install the OPS PC module or remove it from the accessory slot while the display is turned
on.
31
smarttech.com/kb/171415
Resolution
3840 × 2160
3840 × 2160
3840 × 2160
1920 × 1080
Refresh rate
60 Hz
60 Hz
60 Hz
60 Hz