Multiple Unit Power Linking; Fuse Replacement - ADJ VIZ870 User Instructions

Vizi CMY300
With this feature you can connect the fixtures to one another using the powerCON input and
output sockets. The maximum that can be connected is 3 fixtures @ 120V and 7 fixtures @
240V. After the maximum connected fixtures you will need to use a new power outlet.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES TO THE VIZI CMY300 AS
THE POWER CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY!
Vizi CMY300
Unplug the unit from any power source it may be connected to. Once the power has been disconnected,
use a phillips head screw driver to unscrew the fuse holder located next to the powerCON input.
Remove the bad fuse and replace with a new one, and screw the fuse holder back in.
Vizi CMY300
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on
some other DMX devices pin 2 may be 'hot'). Also, check that all cables are connected to the right
connectors; it does matter which way the inputs and outputs are connected.
Vizi CMY300
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried
out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue,
dust, dew).
ADJ Products, LLC - www.adj.com - Vizi CMY300 User Manual Page 44

Multiple Unit Power Linking

Fuse Replacement

Trouble Shooting
Cleaning