Table of Contents
Advertisement
Multiple Unit Power Linking
With this feature you can connect the fixtures to one another using the power cable input and output
sockets. The maximum number of power linked units is
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES AS THE POWER
CONSUMPTION OF OTHER MODEL FIXTURES MAY EXCEED THE MAX POWER OUTPUT ON
THIS FIXTURE! CHECK SILK SCREEN FOR MAX AMPS.
Master-Slave Setup
1.
Using approved DMX data cables, daisy chain your units together via the XLR connector on
the rear of the units. Remember the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use the female XLR connector
only. For longer cable runs, we suggest a terminator at the last fixture.
2.
Set the "Master" unit to your desired mode of operation.
3.
On the "Slave" unit(s), press the UP or DOWN button (from the main menu) until "MENU
Slave" is displayed. Press ENTER and set the unit to "Slave". Each "Slave" unit must be
set to the same setting.
4.
Connect the first "Slave" unit to the "Master." The "Slave" unit(s) should now start following
the "Master" unit.
Installing the Frost Lens
Install the filter in front of the lens and put the included
retainer ring top to hold the lens in place.
Fuse Replacement
Disconnect the unit from its power source. Remove the
power cord from the unit. Once the cord has been removed,
use a flat (slotted) head screwdriver to remove the fuse
holder. Remove the fuse located inside the fuse holder and
replace with the new fuse. Install the fuse holder and new
fuse and secure it.
Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be
carried out periodically to optimize light output.
1.
Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2.
Clean the external optics with glass cleaner and a soft cloth every 20 days.
3.
Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke,
fog residue, dust, dew).
9 units @ 110V or 18 units @ 240V.
24
Advertisement
Table of Contents
