Primary-Secondary Configuration; Multiple Unit Power Linking - ADJ ENCORE FR150Z User Manual

S Y S T E M M E N U
Temperature Infomation - In this submenu you are able to check the fixtures current running
temperature.
1. Plug the fixture in and press the UP or DOWN buttons until "Info" is displayed.
2. Press the ENTER button and press the UP or DOWN buttons until "TempInfo" is displayed, and
press ENTER.
3. Use the UP or DOWN buttons to find the time information you would like to check. Press the ENTER
button to access your desired time information.
Software Infomation - In this submenu you are able to check the fixtures current software.
1. Plug the fixture in and press the UP or DOWN buttons until "Info" is displayed.
2. Press the ENTER button and press the UP or DOWN buttons until "Software" is displayed, and
press ENTER. The current software version will now be displayed. Press the MODE button to exit.
Manual Dimmer Mode:
1. Plug the fixture in and press the UP or DOWN buttons until "Menu Manual" is displayed and press
ENTER.
2. After pressing ENTER, "ManCtrl Dimmer" will be displayed. Press the ENTER button to access the
dimmer adjustment submenu.
3. Once you have entered the dimmer adjustment submenu, use the UP and DOWN buttons to adjust
the dimmer intensity. When you are finished adjusting the intensity, press ENTER.
4. Press the UP or DOWN buttons to switch "ManCtrl Strobe" and press ENTER. Follow the values
listed under the DMX STROBE channel. These values will match with the values in Strobe control.
P R I M A R Y- S E C O N D A R Y C O N F I G U R AT I O N
This function will allows you to link units together to run in a Primary-Secondary set-up. In this type
of set up one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Primary or as a Secondary however, only one unit can be programmed
to act as the "Primary."
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables
to link your units together. Remember that the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (primary) will use the female XLR connector only.
The last unit in the chain will use the male XLR connector only.
2. Connect the first "Secondary" unit to the "Primary."
3. Set the "Primary" unit to your desired mode of operation. On the "Secondary" unit's press the UP or
DOWN buttons until "Function" is displayed, and press ENTER.
4. Press the UP or DOWN buttons until "Disp.Set" is displayed and press ENTER. Press the UP or
DOWN buttons until "Secondry" is displayed and press ENTER.
5. The "Secondary" unit(s) will now follow the "Primary".
6. To exit "Secondary" mode, press the MODE button.
7. To fully exit "Secondary" mode, you will need to follow steps 3 and 4 and set the display to "ADDR"
and press ENTER.
M U LT I P L E U N I T P O W E R L I N K I N G
With this feature you can connect the fixtures using the Power input and output sockets. A maximum
of 7 fixtures can be connected: (7x) @ 120V and 14 fixtures @ 240V. After the maximum connected
fixtures, you will need to use a new power outlet.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES TO THE ENCORE FR15ZAS
THE POWER CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY!
17