Table of Contents
Advertisement
FROST FILTER
The MOD TW100 comes with 3 interchangeable frost filters. To install the frost filter unscrew the four thumb
screws holding lens in place. Remove the lens and install the filter inside the unit. Line up the thumb screw
holes on the edges of filter with screw holes of the unit. Screw the thumb screws back into place securing the
lens. For help contact ADJ Customer Support.
filter
MULTIPLE UNIT POWER LINKING
With this feature you can connect the fixtures to one another using the powerCON input and output
sockets. The maximum that can be connected is 5 fixtures @ 120V and 9 fixtures @ 240V. After the
maximum connected fixtures you will need to use a new power outlet.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES TO THE MOD TW100 AS THE
POWER CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY!
TROUBLE SHOOTING
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on some other
DMX devices pin 2 may be 'hot'). Also, check that all cables are connected to the right connectors; it does
matter which way the inputs and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is activated.
CLEANING
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried out
periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue, dust,
dew).
A.D.J. Supply Europe B.V. – www.americandj.eu – MOD TW100 Instruction Manual Page 23
Advertisement
Table of Contents
