Dmx Addressing - ADJ VIZ870 User Instructions

Hide thumbs Also See for VIZ870:

Table of Contents

Vizi CMY300

DMX ADDRESSING

All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture

responds to the correct control signal. This digital starting address is the channel number from which

the fixture starts to "listen" to the digital control signal sent out from the DMX controller. The assignment

of this starting DMX address is achieved by setting the correct DMX address on the digital control

display on the fixture.

You can set the same starting address for all fixtures or a group of fixtures, or set different addresses

for each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react

in the same way, in other words, changing the settings of one channel will affect all the fixtures

simultaneously.

If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number

you have set, based on the quantity of DMX channels of each fixture. That means changing the settings

of one channel will only affect the selected fixture.

In the case of the Vizi CMY300, when in 24 Channel you should set the starting DMX address of the

first unit to 1, the second unit to 25 (24 + 1), the third unit to 49 (25 + 24), and so on. (See chart below

for more details.)

Channel mode

24 channels

26 channels

38 channels

ADJ Products, LLC - www.adj.com - Vizi CMY300 User Manual Page 11

Unit 1

Unit 2

Address

DMX Addressing

Unit 3

Unit 4

Address

115

Table of Contents

Vizi cmy300