Table of Contents
Advertisement
KINO-CV-D25501/N26001 SBC
Step 4:
Attach PS/2 connectors to the chassis. The keyboard/mouse Y-cable
connector is connected to two PS/2 connectors. To secure the PS/2 connectors
to the chassis please refer to the installation instructions that came with the
chassis.
Step 5:
Connect the keyboard and mouse. Once the PS/2 connectors are connected
to the chassis, a keyboard and mouse can each be connected to one of the
PS/2 connectors. The keyboard PS/2 connector and mouse PS/2 connector are
both marked. Please make sure the keyboard and mouse are connected to the
correct PS/2 connector.
4.8 Software Installation
All the drivers for the KINO-CV-D25501/N26001 are on the CD that came with the system.
To install the drivers, please follow the steps below.
Step 6:
Insert the CD into a CD drive connected to the system.
NOTE:
If the installation program doesn't start automatically:
Click "Start->My Computer->CD Drive->autorun.exe"
Step 7:
The driver main menu appears (Figure 4-12).
Page 61
Advertisement
Table of Contents
