Installing The Display Cable - Dell NOT21988 Owner's Manual

8. Remove the display panel.
About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following image indicates the location of the display cable and provides a visual representation of the removal procedure.
Steps
1. Disconnect the display eDP cable from the connector on the camera module.
2. Carefully peel back and remove the display eDP cable from the display back-cover and antenna assembly.

Installing the display cable

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following image indicates the location of the display cable and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs) 103