Installing the camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
1. Using the alignment post, adhere the camera module on the display back-cover and antenna assembly.
2. Connect the camera cable to the camera module.
Next steps
1. Install the
display
panel.
2. Install the
display
bezel.
3. Install the
hinge
caps.
4. Install the
display
assembly.
5. Install the
WLAN
card.
6. Install the
base
cover.
7. Exit
service
mode.
8. Install the
SD
card.
9. Follow the procedure in
Display eDP cable
Removing the eDP cable
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Enter
service
mode.
4. Remove the
base
cover.
5. Remove the
WLAN
card.
6. Remove the
display
assembly.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
67