Steps
1. Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
2. Replace the four (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
3. Connect the touchpad cable to the system board and close the latch.
4. Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
5. Replace the three (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
rear
cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
54
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.