H e l p f u l R e m i n d e r s
Always start with a fully charged battery.
Attach the safety strap to your wrist before using the printer.
Do not pound the printer when applying labels printed in peel mode.
Switch to a fully charged battery every time you load a new roll of supplies (doing so ensures
optimum print quality).
Turn off the printer when you are not using it.
Operate and store the printer with the recommended temperature and humidity ranges.
See Appendix A, "Specifications and Accessories," for more information.
A t t a c h i n g t h e S a f e t y S t r a p
1. Turn the printer upside down, resting its top on the table.
2. Remove the stylus strap from the loop.
3. Take the thin end of the safety strap, and push it through the loop at the bottom of the
printer handle (near the battery compartment).
4. Push the thick end of the safety strap through the thin end's loop.
5. Pull the strap. It may be necessary to help the thin end's loop fit over the plastic piece in the
middle of the strap and pull the strap tight.
6. Attach the stylus strap to the loop as shown.
Introduction 1-3