Decommissioning, Dismantling, Disposal; Take The Machine Out Of Operation; Dismantling The Machine; Machine Disposal - Avery Dennison ALS 204 Installation Manual

3 I
NSTALLATION UND
2.3 D
ECOMMISSIONING
2.3

DECOMMISSIONING, DISMANTLING, DISPOSAL

Take the machine out of
2.3.1
operation
Disconnecting the machine from the compressed air
supply (only machines with installed applicator):
Switch off the compressed air supply of the applica-

tor.
Disconnect the compressed air hose from the appli-

cator.
– For details read the applicator installation manual.
Disconnect the machine from the power supply:
Switch the machine off at the mains switch (switch

position „0" or „switch illumination off" for machines
with splash guard).
Pull out the mains plug from the mains socket or dis-

connect the power cord from the electrical cabinet.
Disconnect all cables at the machine.


Dismantling the machine

2.3.2
Machine with installed applicator:
Remove the applicator.

– For details read the applicator installation manual.
WARNING!
Danger of injury by the machine falling to
ground.
Let the machine be hold by at least 2 per-

sons, while a 3rd person loosens the
clamping at the support stand.
Wear safety footwear.

Acute risk of injury and long-term bodily in-
jury from working with heavy loads!
Lift or carry the machine with a minimum

of 2 persons. If possible, use a crane or
other lifting device.
CAUTION!
To avoid damaging the machine during
transport:
Never hold the machine by the deflection

rollers, dancer arm or rewind or unwind
unit.
Let the machine be held by at least 2 persons, while

a 3rd person loosens the clamping at the support
stand.
– While doing so, hold the machine at its housing.
D
EINSTALLATION
, D
ISMANTLING
Strip the machine from the support stand tube and

lay it down.
2.3.3
Remove machine parts which can be reused (e. g.

applicator, applicator interface, dispensing edge
holder, dispensing edge).
Dispose of the remaining machine parts separated

by material groups in an environmentally acceptable
manner. Observe the national regulations.
– Dispose of waste properly, i.e. sorted according to
the material groups of the parts to be disposed of.
The aim should always be to achieve a maximum
possible reutilisation of the basic materials com-
bined with the minimum possible environmental im-
pact.
41
, D
ISPOSAL

Machine disposal

It is advisable to remove reusable machine
components as long as the machine is firmly
mounted.
ALS
20X
256